Atlantic Technology IWTS-7 LCR - Manual (Page 2)

Specs
IWTS-7 LCR IWTS-14 LCR
Type 2-way 2½-way
Drivers Woofer 6½" (165mm) GLH § (2) 6½" (165mm) GLH §
Tweeter 1" (25mm) silk dome 1" (25mm) silk dome
Frequency Response 53-20kHz, +/- 3dB 47-20kHz, +/- 3dB
Nominal Impedance 6 Ω 6 Ω
Crossover Frequency 2.1kHz 800Hz, 2.1kHz
Sensitivity 87dB 87dB
Recommended Power 10– 100 Watts RMS 10-125 Watts RMS
Dimensions 9¼ x 17¾ x 3 7 ⁄
8
” 10 13 ⁄
16
x 19 x 3 7 ⁄
8
”
(W x H x D) 236 x 449 x 100mm 274 x 484 x 100mm
Cutout Dimensions 8 1 ⁄
8
x 16½” 9 5 ⁄
8
x 17 7 ⁄
8
”
(W x H) (207 x 420mm) (245 x 454mm)
Net Weight (ea) 7lbs; 3.2kg each 9lbs; 4.1kg each
§ Graphite Loaded Homopolymer
*IR Receiver not included
For ease of installation and total
flexibility/convenience, the IWTS-7
uses the same grill/frame assembly
and New Construction Bracket as
the IWCB-52 (the GFR-52/7 and IN-
NC-52/7) and the IWTS-14 uses the
same grille/frame assembly and New
Construction Bracket as the IWCB-525
(the GFR-525/14 and IN-NC-525/14).
The systems are uniquely easy to mount, since their GFR
grille/frame assemblies are sold separately. This means
the installer can run the wire to the speaker locations,
then mount and paint the grille/frames to match the room.
The speaker assemblies can be installed at a later time if
desired, optimizing the timing of the project. The main difference between the two models is that the
IWTS-14’s dual-woofer, 2½-way configuration will handle
more power and thus delivers greater output in a larger
room than the IWTS-7.
Boundary Compensation, High Frequency
Energy and Directivity switches
Atlantic’s renowned 1” LRT™ soft
dome tweeter
Paintable grille and frame
IR punchout*
©2008 Atlantic Technology • 343 Vanderbilt Ave.
Norwood, MA 02062 • 781.762.6300
www.atlantictechnology.com 3.08
Atlantic Technology is a registered trademark of Atlantic Technology
International. Specifications subject to change without notice.
IWTS-7 & 14 In-Wall HT Systems