Grounding instructions – Electrolux EI30BM55HS User Manual

Page 6

GROUNDING INSTRUCTIONS

Figure 1

Ground

Receptacle

Opening for
Power Cord

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-
ing plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance
with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the electric current.

Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The oven is equipped with a 3-prong grounding plug. DO
NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE
THE GROUNDING PIN FROM THE PLUG.

DO NOT USE AN EXTENSION CORD.

If the power supply cord is too short, have a qualified electri-
cian or serviceman install an outlet near the appliance.

The Power Supply Cord and plug must be connected to
a separate 120 Volt AC, 60 Hz, 15 Amp, or more branch
circuit, single grounded receptacle. The receptacle should
be located inside the cabinet directly above the Microwave
Oven mounting location as shown in Figure 1.

NOTES:

1. If you have any questions about the grounding or electri-

cal instructions, consult a qualified electrician or service
person.

2. Neither Electrolux nor the dealer can accept any liability

for damage to the oven or personal injury resulting from
failure to observe the correct electrical connection
procedures.

Radio or TV Interference

Should there be any interference caused by the microwave
oven to your radio or TV, check that the microwave oven is
on a different electrical circuit, relocate the radio or TV as
far away from the oven as feasible or check position and
signal of receiving antenna.

ORM 2.0 Bottom [TINSEB310WRRZ] [6 6

10/19/10 1:21:36 PM