Electrolux EWDW6505GS - Manual (Page 8)

8 Operating Instructions
STATUS WINDOW
NOTE
Opening the door during normal operation will
only pause the selected cycle.
Start/Cancel
To start a cycle, press the START touchpad once
and close the door. To cancel when a cycle is
running, open the door and press the CANCEL
touchpad once. Close the door again and the
dishwasher will drain and shut off.
Error Indications
In certain situations which are critical to the ma-
chine function and safe operation, the control shall
shut down and indicate an error code ‘Er’ (See Error
Codes on page 21). On units without a display, all
indicator lights will flash.
If one of these codes are displayed contact the
Electrolux Customer Care Center at 1-877-435-
3287 . They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.
Wash Pressure
The WASH PRESSURE option allows you to select
the desired wash pressure depending on your
dishload. When HIGH WASH PRESSURE is
selected, the system automatically adjusts the
pressure up to provide faster and more effective
cleaning. When LOW WASH PRESSURE is
selected, the wash pressure is decreased to clean
delicate dishes without damage. When AIR DRY is
selected, heat dry will not be activated this will
conserve energy and time.
When BLUE LIGHT luminates on the floor this
indicates that the wash cycle is complete.
BLUE LIGHT
CHIME
These models are equipped with a chime to audibly
indicate when you have pressed a cycle or
selected an option. The chime also signals the
completion of the selected cycle.
To adjust the volume press the “SELECT OPTION”
touchpad. Then toggle using the
> touchpad until
VOLUME SETTING is displayed. Press the “SET”
touchpad and then toggle using the
< or >
touchpads until the desired volume is reached.
Press the “SET” touchpad to save your selection.
DISABLE THE DISPLAY
The disable the display feature may be used when
observing the Jewish Sabbath/Holidays and the
dishwasher may be used for storage during this
time.
When the display is properly disabled, the
dishwasher will not provide any audibles or text
messages.
You can set your wash cycle to run. To do this,
press Start, then disable the display and close the
dishwasher door. After the completed wash cycle
the clean light will remain ON even when you open
or close the door during this time. The clean light
will shut OFF automatically 2 hours after the
completed wash cycle.
You can also disable the display without setting a
wash cycle.
To disable the display press and hold the left
arrow key for 10 seconds. To reactivate the
display, press and hold the left arrow key for 10
seconds.
30MIN-24HRS Indicates number of delay start
hours for selected cycle.
CLOSE DOOR Displayed once the program has
been entered and the START/
CANCEL touchpad is pressed. It
also flashes if the door is
opened during a wash cycle.
Close the dishwasher door to
begin or continue a wash cycle.
WELCOME Appears in window 3 seconds
when dishwasher is first
installed, or when power has
been interrupted.
The STATUS window displays codes typically seen
during programming of the dishwasher. The window
will not display anything when the door is closed.
The STATUS window indicates the following activity: