Electrolux EIDW1805KS - Manual (Page 2)

High standards of quality at Electrolux Home Products, Inc. mean
we are constantly working to improve our products. We reserve the right
to change specifications or discontinue models without notice.
Meets
requirements of
ASSE 1006
Built-In Dishwasher Specifications
• Product Weight – 66 Lbs.
• Voltage Rating – 120V/60 Hz/15 Amps (maximum 20 Amps if
connected with disposer)
• Connected Load (kW Rating) @120 Volts = 1.44kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded for
safe operation.)
• Amps @120V = 9 Amps
• Always consult local and national electric & plumbing codes.
Meets requirements of ASSE 1006.
• Water Pressure – Hot water line to dishwasher must provide between
15 and 120 pounds per square inch (psi).
• Dishwasher enclosure requires that adjacent cabinets be square and
plumb. Unit must be fully enclosed on top, sides and back; and not
support any part of enclosure.
• For A.D.A. installation, (32-1/2") beneath 34"-high countertop may be
accomplished by adjusting toekick and leveling legs.
• When installing unit adjacent to wall, cabinet or other obstruction that
extends beyond front edge of unit, allow 2" minimum clearance between
opened door and obstruction.
• Do not install unit beneath cooktop, damage will occur.
• Make sure location has required drain, water and electrical outlets to
make proper connections.
• Air gap required if drain is connected to waste tee or disposer lower than
18" above floor. If no air gap required, minimum 32"-high drain loop must
be used. Total drain hose length must not exceed 10' to drain outlet.
• Electrical and water supplies should enter enclosure on floor, or through
rear or cabinet side walls, as shown in designated shaded area. Hot water
line may pass through same hole as electrical cable and drain hose; or
through additional 1-1/2" dia. hole designated to accommodate line.
• Water connection located on left side of dishwasher. Install hot water inlet
line using no less than 3/8" O.D. copper and extend forward at least 18"
from rear wall with hand shut-off valve accessible beneath sink.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
Electrolux Major Appliances, N.A.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca
EIDW1805K 12/13 © 2013 Electrolux Home Products, Inc.
Dishwasher
EIDW1805K S
18" Built-In Dishwasher
EIDW1805K