Electrolux EIDW1805KS - Manual (Page 11)

11
See Installation Instructions for more details on
disconnecting and restoring service to your
dishwasher.
NOTE
Care & Cleaning
Outside
—Occasionally wash with a mild
nonabrasive detergent and water. Rinse and dry.
Inside — The inside of the dishwasher is self-
cleaning with normal use.
To clean stainless steel wipe with the grains.
Use a Dishwasher Safe Detergent to help with the
stains or discolorations.
NEVER
use products that contain Chlorine
Bleach or Citric Acid.
Important: The dishwasher motor is
permanently lubricated at the factory and does
not need to be oiled.
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. Drain air gaps are
usually mounted on countertop and can be
inspected by removing the cover. A drain air gap is
not part of your dishwasher and is not covered by
this warranty.
WINTERIZING
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or tripping
circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a NORMAL WASH Cycle.
4. Check connections to make sure they do not
leak.
Care of Drain Air Gap
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person do
the following:
See Installation Instructions for more details on
disconnecting and restoring service to your
dishwasher.
NOTE
Allow heating element to
cool before cleaning the
interior.
Failure to do so can result
in burns.
Burn Hazard