Zanussi FL 574 CN - Manual (Page 18)

18
SOMETHING NOT WORKING
■
Problem
■
Possible cause
■
The machine does not start up: ■ Check that the door is firmly closed.
■ Check that the machine is plugged in and
that there is power at the socket.
■ Check that the main fuse has not blown.
■ Check that the programme selector dial is
positioned correctly and pulled out.
■
The machine does not fill: ■ Check that the water tap is open.
■ Check that water is coming out of the tap.
■ Check that the inlet hose is not squashed or
kinked.
■ Check that the filter in the inlet hose is not
blocked.
■ Check that the door is closed.
■
The machine does not empty
and/or does not spin: ■ Check that the drain hose is not squashed or
kinked.
■ The spin suppression or anti-crease
option has been selected.
■
There is water on the floor: ■ Too much detergent or unsuitable detergent
(creates too much foam) has been used.
■ Check whether there are any leaks from one
of the inlet hose fittings. It is not always easy
to see this as the water runs down the hose;
check to see if it is damp.
■ Check that the drain hose is not damaged.
■
Unsatisfactory washing results: ■ Too little detergent or unsuitable detergent
has been used.
■ Stubborn stains have not been treated prior
to washing.
■ The correct temperature or programme was
not selected.
■
The machine fills then empties
immediately: ■ The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage”
section.
Problems which you can resolve yourself