Axis AX-333 - Manual (Page 10)

Axis Nitris and Axis Fuel |1| english Axis Nitris and Axis Fuel |1| english
4. When finished cleaning, reseat the inner cutters
on the mounts and replace the hairpocket, mak-
ing sure it locks into place.
Note: to ensure proper operation, the outer foil
frame assembly must be properly seated. To
avoid damaging the delicate foil screens, do not
remove them from their frame.
Worldwide Voltage
This shaver features worldwide automatic dual
voltage conversion for 100-240 volt, 50-60 Hz AC
current. You can plug the power/recharging cord into
an electric outlet virtually anywhere in the world (an
adapter plug may be necessary), and the shaver will
adjust automatically to the required voltage.
Recharging the Shaver
AX-3335 features a 5-stage LED power indicator. (fig. 1)
AX-3331 features a green indicator light that flashes when recharging
is needed, remains on while the shaver is charging, and turns off when
the shaver is fully charged. Use only the power/recharger cord that
came with the shaver. The shaver is also designed to be used while
plugged into an electric outlet. The unit will not charge while it is in use,
so be sure to turn the unit off to allow charging when you are finished
shaving. The shaver will provide a 3 minutes shave after 5 minutes of
charging.
5 Stage Power Indicator
Bottom LED Flashing: recharging required
LEDs Flash Sequentially and Then Lit: shaver is recharging
Fig. 3
Fig. 4 Fig. 5
5
Fig. 2
5 Stage Power Indicator
Bottom LED Flashing - Recharging Required
LEDs Flash Sequentially and Then Lit - Shaver is Recharging
All LEDs Lit - Shaver is Fully Recharged
LEDs Light Sequentially - Shaver is Operating Normally
Fig. 1
1