AKG Acoustics WMS 300 - Manual (Page 3)

Microphones · Headphones · Wireless Microphones · Wireless Headphones · Headsets · Electroacoustical Components
Limited Warranty
Valid only in the United States. AKG Acoustics warrants AKG products against defects in material
or workmanship for a period of two years from the date of original purchase for use, and agrees to
repair or, at our option, replace any defective unit without charge for either parts or labor. Important:
This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable
care, the affixing of any attachment not provided with the product, loss of parts or connecting the
product to any but the specified receptacles. This warranty is void unless service or repairs are
performed by an authorized service center. No responsibility is assumed for any special, incidental
or consequential damages. However, the limitation of any right or remedy shall not be effective
where such is prohibited or restricted by law. Simply take or ship your AKG product prepaid to our
service department. Be sure to include your sales slip as proof of purchase date. (We will not repair
transit damage under the no-charge terms of this warranty.) Note: No other warranty, written or oral
is authorized by AKG Acoustics, Inc. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damages or limitation on how long an implied warranty
lasts, so the above exclusions and limitation may not apply to you.
Specifications subject to change without notice.
AKG Acoustics GmbH
Lemböckgasse 21–25, P.O.B. 158, A-1230
Vienna/AUSTRIA
Tel: (43 1) 86 654-0*, Fax: (43 1) 86 654-516
Internet: http://www.akg.com
AKG Acoustics; A Division of Harman Pro Germany
Bodenseestraße 228, D-81243 München/GERMANY
Tel: (089) 87 16-0, Fax: (089) 87 16-200
Arbiter Pro Audio
Wilberforce Road, London NW9 6AX/ENGLAND
Tel: (0181) 202 1199, Fax: (0181) 202 7076
AKG ACOUSTICS, U.S.
914 Airpark Center Drive
Nashville, TN 37217, U.S.A.
Tel: (615) 620-3800, Fax: (615) 620-3875
Studer Japan Ltd.
2-43-7, Uehara, Shibuya-ku, Tokyo 151-0064/JAPAN
Tel: (813) 3465-2211, Fax: (813) 3465-2214
Erikson Pro Audio
620 McCaffrey, St-Laurent, Quebec, H4T 1N1, CANADA
Tel: (514) 738-3000, Fax: (514) 737-5069
Internet: www.jam-ind.com/eriksonpro
AKG is constantly impr
oving and modifying its pr
oducts, ther
efor
e, specifications ar
e subject to change without notice.
The wireless microphone system shall operate over the UHF
frequency range from 766 to 805 MHz range, with transmitter
power not exceeding 10 milliwatts. Both handheld and
bodypack type transmitters shall be provided. The bodypack
transmitter shall accommodate both microphone and line level
inputs. The transmitters shall operate with a companding system
that is complemented by the receiver, providing an A-weighted
system dynamic range in excess of 100 dB. The transmitters
shall indicate input overload and low battery power. Handheld
transmitters shall have a maximum diameter of 2.125 in. (53 mm)
and a length, including antenna, no greater that 11.125 in. (282
mm). The receiver shall operate on the true diversity principle,
and that action shall be inaudible as such. Adjacent channel
isolation shall be at least 60 dB, and total harmonic distortion at
1 kHz for rated deviation shall be no greater than 0.8%. The
receiver shall provide for a manual squelch adjustment for
optimum system operation. An output level adjustment shall be
provided, and there shall be both balanced XLR-M output and
unbalanced 0.25 in. (6.5 mm) jack.
The wireless microphone system shall incorporate factory optimized
sets of both sending and receiving frequency modules that are built into
both transmitters and receivers. Each frequency set shall comprise a 20
MHz UHF band and offer at least 16 discrete operating frequencies within
that band. The wireless microphone system shall be the AKG Acoustics
Model WMS 300.
Graphical Data
Architects and Engineers Specifications
DS-WMS 300
Accessories: RMU2A 2-Unit rack mount mainframe with passive splitter
RMU2 1-Unit rack mount mainframe
P300 System antenna splitter
RA300B Remote antenna for antenna splitter