Iii. installation, Installation steps, Jumpers – Asus P/I-P55T2P4S User Manual

Page 12

ASUS P/I-P55T2P4S User’s Manual

III. INSTALLATION

Installation Steps

Before using your computer, you must complete the following steps:

1. Set Jumpers on the Motherboard
2. Install DRAM Modules
3. Install the Central Processing Unit (CPU)
4. Install Expansion Cards
5. Connect Ribbon Cables, Cabinet Wires, and Power Supply
6. Setup the BIOS Software

1. Jumpers

Several hardware settings are made through the use of jumper caps to connect jumper

pins (JP) on the motherboard. See "Map of the Motherboard" on page 4 for loca-

tions of jumpers. The jumper settings will be described numerically such as [----],

[1-2], [2-3] for no connection, connect pins 1&2, and connect pins 2&3 respec-

tively. Pin 1 for our motherboards is always on top

Pin 1

or on the left

Pin 1

when

holding the motherboard with the keyboard connector away from yourself. A "1" is

written besides pin 1 on jumpers with three pins. The jumpers will also be shown

graphically such as

to connect pins 1&2 and

to connect pins 2&3.

Jumpers with two pins will be shown as

for Short (On) and

for Open

(Off). For manufacturing simplicity, the jumpers may be sharing pins from other

groups. Use the diagrams in this manual instead of following the pin layout on the

board. Settings with two jumper numbers require that both jumpers be moved to-

gether. To connect the pins, simply place a plastic jumper cap over the two pins as

diagramed.

WARNING: Computer motheboards and components contain very delicate
Integrated Circuit (IC) chips. To protect the motherboard and other compo-
nents against damage from static electricity, you should follow some precau-
tions whenever you work on your computer.
1. Unplug your computer when working on the inside.
2. Hold components by the edges and try not to touch the IC chips, leads, or

circuitry.

3. Use a grounded wrist strap before handling computer components.
4. Place components on a grounded antistatic pad or on the bag that came with

the component whenever the components are separated from the system.

(Jumpers)

III. INST

ALLA

TION