beautypg.com

Aube Technologies aube TH106 User Manual

Th106, User guide, Description

background image

TH106

400-106-001-D 12/8/05 1/3

This programmable thermostat can be used to control an electric
heating system such as an electric baseboard heater, a radiant ceil-
ing, a radiant floor, a convector, etc.

The thermostat cannot be used under the following conditions:

The resistive load is greater than 16.7 A

The resistive load is less than 2 A

The system is driven by a contactor or relay (inductive load)

The system is a central heating system

SUPPLIED PARTS:

One (1) thermostat

Two (2) 6-32 screws

Two (2) solderless connectors

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
THE INSTALLATION MUST BE PERFORMED BY AN ELECTRI-
CIAN.

All cables and connections must conform to the local electrical
code.

Special CO/ALR solderless connectors must be used when con-
necting with aluminum conductors.

Install the thermostat onto an electrical box.

Install the thermostat about 5 feet high, on an inside wall facing
the heater.

Avoid locations where there are air drafts (such as the top of a
staircase or an air outlet), dead air spots (such as behind a
door), or direct sunlight.

Do not install the thermostat on a wall that conceals chimney or
stove pipes.

The thermostat wires are not polarized; either wire can be con-
nected to the load or to the power supply.

NOTE:

Always keep the thermostat's vents clean and unobstructed.

n

o

Connect the thermostat wires to the line wires and to the load
wires using solderless connectors for copper wires.

p

Push any excess wire back into the electrical box.

NOTE:

If necessary, before re-installing the front component, config-

ure the thermostat (see section 3).

q

Return power to heating system.

n

Description

1.

o

Installation

2.

Select the
operating mode

Set the time

Time and day

T

emperature

Operating
mode icons

Skip a period

Program the
schedule

Temperature
preset icons

Temperature
adjustment
buttons

Temperature
preset buttons

Heating power
indicator

Periods

Appears when the
setpoint is displayed

Set the day

2-wire installation

4-wire installation

TH106

User Guide

Programmable Thermostat