Accel TEMPEST 3302 - Manual (Page 3)

GENERAL INFORMATION
3
ELECTRICAL
REQUIREMENTS
IMPORTANT
INFORMATION
SAFETY
INFORMATION
TERMINOLOGY
220 VAC 50/60 HZ
20 AMP DEDICATED LINE
NEMA L620R RECEPTACLE
The use of heat to accelerate drying may require more frequent
lubrication and/or use of a high temperature lubricant in the delivery of
the press. Please consult your press manufacturer for specific recom-
mendations.
The Tempest ® Dryer contains high voltage and hot surfaces. Never
attempt to service or work on the unit unless the power is shut off and
the unit is cool.
Visually inspect the thermistors (Barn housed-shaped objects ar-
ranged in a honeycombed pattern on the underside of the unit) weekly.
If a thermistor is damaged or cracked, do not operate the dryer. Contact
Accel immediately for a replacement part.
The fans should be turned on and set at the lowest speed ("0" on the
dial) when running spray powder only without heat. This prevents
spray powder from accumulating in the thermistors and housings.
OPS = Operator's Side
NOPS = Non Operator's Side