beautypg.com

Closing the door – AEG A81000TNX0 User Manual

Page 13

background image

Problem

Possible cause

Solution

Large quantities of food to be

frozen were put in at the same

time

Insert smaller quantities of food

to be frozen at any one time.

Food placed in the appliance

was too warm

Allow food to cool to room tem-

perature before storing.

Products to be frozen are placed

too closely to each other

Place the products in a way so

that cold air could circulate

among them

It is too cold inside the

freezer

Temperature regulator may be

set incorrectly

Set a warmer temperature

The appliance does not

work at all. Neither cool-

ing nor lighting works

Plug is not connected to the

mains socket properly

Connect the mains plug properly

Power does not reach the appli-

ance

Try connecting another electrical

device to the power outlet

The appliance is not switched on Switch on the appliance

There is no voltage in the mains

socket (try to connect another

appliance into it)

Call an electrician

The appliance does not

cool at all

Plug is not connected to the

mains socket properly

Connect the mains plug properly

There is no voltage in the mains

socket (try to connect another

appliance into it)

Call an electrician

The appliance is not switched on Switch on the appliance

A rectangular symbol is

shown on the right side of

the Temperature Display

Temperature sensor problem

Call the service personnel

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

What to do if…

13