Sterlco GH-F Series Gravimetric Additive Feeder - Manual (Page 29)

Chapter 3: Installation 29 of 60
Controller Set-up
This section describes the proper setup of the GH system control parameters. These
parameters are operator changeable; however, these items should only require setup during
the initial installation. Only authorized personnel should change them. For security reasons,
the menu that is used to access these parameters is password protected.
Many of the variables and setup parameters have been preset at the factory and do not need to
be changed. However, this section of the manual will address all of the rate monitor setup
parameters that were available at the time of printing. The purpose of this is to familiarize the
reader with all the setup parameters and their usage.
A complete listing of all default values is provided at the end of this manual.