Raytec UBF16 - Manual (Page 10)

10
Trouble Shooting
ensure all tests are undertaken by a qualified, trained engineer.
ensure safe working practices are followed at all times
Step 1: Basics
• Check polarity of WHITe-LIGHT Lamp connection
red=+ve, black=-ve
• Check telemetry link is in
• Check photocell is working
• Check power setting pot fully clockwise
• Check mains input
• Check fuse intact
If OK…
Step 2: Lamp Test
Check voltage of lamp o/p approx 14V
Check current of lamp – see instructions for correct current setting
To check lamp current (this must be done while both Led panels
are connected to the PSU) remove +ve Led from both lamp supply
cables and connect multimeter set to 10A current in line with the
lamp. [One lead of multimeter in common (COM), other lead into
10A socket of multimeter; set multimeter to 10A readings]. Refer to
PSU Specifications for correct current settings, see pages 7.