Trouble shooting, Step 1: basics, Step 2: set-up camera, lens and illumination – Raytec RAYMAX 25 PoE User Manual

Page 5: Step 3: call raytec for further assistance

Trouble Shooting

Step 1: Basics

Check blue LED ‘power on’ light is illuminated on the back of the PoE unit.

Yes,

• Ensure power adjust is turned to the maximum level.
• Ensure Photocell is covered and if necessary adjust the photocell

sensitivity.

No,

• Confirm that the PoE injector unit is fully functioning.

nB: Refer to manufacturer’s guide
• Check that the cable is fully intact, and not broken or split.

Step 2: Set-up Camera, lens and illumination

Check alignment of lamp
Check camera lens – fully open at night & set correctly.
Check model number to Raytec performance specification to ensure

required distance is achievable.

Step 3: Call Raytec for further assistance

note down:
• Model and serial number of illuminator
• Camera make and model
• Lens make and model
If the Raytec lamp is still not delivering the required performance, please