Avanti MO9005BST - Manual (Page 14)

14
SETTING A COOKING PROGRAM
A. One-stage Cooking
1. Use the number pads to set a cooking time.
You can set a cooking time from one second to
99 minutes and 99 seconds.
2. If you want to set a power level other than
100% power, touch POWER, then use the
number pads to enter the power level. You can
set the power level from 1 to 9.
Use single digits to set a cooking power level:
3. Touch START/STOP to start cooking.
Number pad Cooking power
9 90%
8 80%
7 70%
6 60%
5 50%
4 40%
3 30%
2 20%
1 10%
B. Multi-stage Cooking
For added convenience your oven offers the ability
to operate in a “Multi-Stage” cooking cycle. Each
cycle or stage can be set with a separate cooking
time and or power level.
a) To set the oven in Multi-Stage cooking
model, simply set the time and power level
of the first stage (as described in Section
One-Stage Cooking to the left).
b) To set the second cooking stage, press the
COOK key (“MEM” will appear in the
display window).
c) Select the desired cooking time and power
level for the second stage.
d) Press “Start” to begin the cooking process.
NOTE:
After cooking stage 1 has elapsed, you will hear
one “beep” sound, signaling the beginning of
stage 2. After the total time (selected cooking
times for both stages) has elapsed, 4 “beeps”
will sound and “END” will appear in the display
window. Touch the “RESET” button or open the
oven door to clear or end the cooking program
before starting another cooking function.
SPEED DEFROST
1. Touch SPEED DEFROST.
2. Enter desired defrosting time by touching
correct number pads. Digital timer sets minutes
and seconds from left to right so a single digit
can be set (5 for 5 seconds ) or up to 4 digits
(2405 for 24 minutes 5 seconds).
3. Touch START/STOP.
NOTE:
After time has elapsed four signals sound and END
appears in display. Touch RESET pad or open door
to clear END before starting another cooking
function.
DEFROST BY WEIGHT
1. Touch DEFROST BY WEIGHT pad.
2. Enter weight.
3. Touch START/STOP pad.
Note:
Weight must be in pounds and ounces.
Ounce weights less than 10 must be preceded by
a 0. If label gives weight in pounds only, change
the fraction of a pound to ounces using the
following chart (See page 14).