beautypg.com

Avanti IMD250 User Manual

Page 12

background image

12

Dispensing ice.

 Place the glass or cup directly below the dispenser and press gently against the dispenser

actuator.

 Remove the amount of ice as desired by continuously pressing against the dispenser actuator.

 Once the desired amount of ice has been dispensed release the dispenser actuator and the

machine will stop dispensing ice.

CARE AND MAINTENANCE

Caution
Failure to unplug the ice maker could result in electrical shock or personal injury.


Cleaning Your Ice Maker

 To ensure the cleanliness of the ice cubes,

water in the reservoir should be replaced every
24 hours.

 Remove the drain plug to drain remaining water

from the water reservoir when the ice maker will
not be used for long period of time. Screw the
drain plug back in place after the water has
been drained.

 Always change with fresh water before starting

ice production at initial installation or after long
shut-off periods.

 Please clean your Ice maker regularly. When

cleaning, unplug the unit and remove the ice
cubes. Use a diluted solution of water and
vinegar to clean the inside and the outside
surface of the Ice maker. Do not spray Ice
maker with chemicals or diluted agents such as
acids, gasoline or oil. Rinse thoroughly before
starting.


Space Requirements

 During transportation, the incline angle of the cabinet should not be over 45°
 Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed

system.

 The Ice maker should be placed horizontally on a properly leveled surface.

 To ensure proper ventilation for your Ice maker allow 6” of space at the top, the back and on each

side.

 Before using the Ice maker for the first time, please wait 2 hours after positioning it.

 Clean the inner liner, ice-bin, water box, water cup frequently.


IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.


Power Failure

Most power failures are corrected within a few hours and should not affect the temperature of your ice
maker if you minimize the number of times the ice-bin is opened. If the power is going to be OFF for a
longer period of time, you need to take the proper steps to disconnect your appliance.