Ampeg BA-108 - Manual (Page 6)

BA-108 / BA-110 Bass Guitar Combo
6
BA-108 / BA-110 Top and Rear Panels
11 10 8 9 7 6 5 4 3 1 2
/N
BA-1XX
)NPUT 0OWER
-15dB 0dB (EADPHONES
#$
5
4
3
2 8
7
1 9
6
0 10
6OLUME
5
4
3
2 8
7
1 9
6
0 10
4REBLE
5
4
3
2 8
7
1 9
6
0 10
-ID
5
4
3
2 8
7
1 9
6
0 10
"ASS
5
4
3
2 8
7
1 9
6
0 10
#$
10. ON LED: This LED illuminates red when
the power is on.
12. EFFECTS RETURN JACK: Use this
1/4" TS unbalanced input to return the
processed line-level output of an external
effects processor (for example). The
processor could be fed by signals from
the effects send.
13. EFFECTS SEND JACK: Use this 1/4"
TS unbalanced output to send a line-level
output to an external effects processor
(for example). The output here is
affected by all controls except the
volume.
Use the effects return jack to feed the
returned processed signals back into the
power amplifier.
11. POWER SWITCH: Use this switch to
turn the overall system power on or off.
Press the top of the switch to turn on
the power, and press the bottom to turn
it off.
12 13 14
%FFECTS
Send Line out Return
14. 1/4" LINE OUT JACK: Typically, you
would connect this post-EQ, unbalanced
output to the unbalanced input of an
external mixer, or a recorder. In this way,
you do not have to mic the speaker
cabinet in order to add it to the main
mix, or to record. The level of this signal
is affected by the volume control.
This output can connect to external
power amplifiers, or powered
loudspeakers, as long as they have their
own input controls to adjust the volume
level.