Audient ASP510 Surround Sound Controller - Manual (Page 11)

Operation Manual
11
Functions & Controls
©audient 5/2001
ASP510 REMOTE
CONTROL
The ASP510 enables the
user to select any one of 5
primary monitor formats:
5.1, LCRS, Stereo, Mono or
Bypass.
A switchable 120Hz filter
is provided for the sub-
bass monitor path (see
page 12).
A 5.1FILM mode is also
implemented with the Left
surround and Right
surround monitor channels
attenuated by 3dB.
Switching for alternate Left
and Right speakers is
provided along with a
Bypass mode enabling
monitoring direct from the
mixing console or DAW.
If the logic sense ports
have been connected to
the host mixing console
the ASP510 will
automatically detect and
action console Solo, Dim
and talkback commands.
1. MONITOR FORMAT is
selected using these
five switches. An
illuminated legend
displays the selected
choice from 5.1, LCRS,
Stereo, Mono and
Bypass. All of these
format selction buttons
are interlocked to
automatically cancel
the previous selection
except Bypass which
o p e r a t e s
independently.
To set the 5.1 format
to FILM mode hold
down the 5.1 button
until it flashes and then
release. To cancel this
mode hold down the
5.1 button until it stops
flashing.
FORMAT SELECTION
3. Remote to Rack unit
link connector.
SURROUND CO NTROLLER
BUS E NC O/P
SURROUND
STEREO
ENCODER/
DECODER
MONITOR SOURCE
STEREO RECOR D SOURC E
MONITOR FOR MAT
ISOL ATE
GUIDE MODE
VOLUME
SURROUND CO NTROLLER
1 2 3
2. ALT switches the main
Left and Right speaker
outputs from the main
monitors to the
Alternate (usually small
near-field) monitors.
.
Bypass disables all
ASP510 functions
other than the Alternate
speaker switching (see
below).To exit from
Bypass mode push the
button again.
To restore factory
default settings hold
down the Bypass
button until it flashes
and then release it.
Bypass sets the entire
ASP510 into stereo
mode connecting the
console control room
outputs directly to the
Left and Right
speakers.