Time Electronics 7095 Hydraulic Calibration Hand Pump - Manual (Page 2)

2
7095 User Manual 2
1.
Introduction
The 7095 Hydraulic calibration hand pump is designed for ease of use with a fully
adjustable stroke control providing quick priming, easy pumping and a fast pressure
generation up to 700 bar (10,000 psi), fine control of the desired set point pressure is
achieved with use of the vernier control.
The pump has changeable built in filters to the output and gauge ports. The shatterproof
reservoir and stainless steel construction ensure reliable leak free operation.
Specification
Output Range: 0 to 700 bar (0 to 10,000psi)
Gauge Port: 3/8” BSP (blanking plug fitted)
Process (UUT) Connection: 1/4” BSP (Fitted Minimess TP)
Reservoir Capacity: 130mL
Materials: Stainless steel fittings, polyurethane anodized aluminium housing,
plastic/rubber handles, PTFE, nitrile o-rings.
Weight: 1.36kg.
• 7095 pump
Contents
• Minimess/1/4” BSP high pressure hose
• 1/4” BSP blanking plug
• Selection of spare bonded washers, filters, washers and o-rings.
• Carry Case
2.
Operational Notes
 Do not exceed 700bar (10,000 psi), the 7095’s maximum pressure.
 Do not try to achieve 700bar by pump action alone.
 The filler cap incorporates a small breather valve, it is normal for a very small amount of
media fluid to trickle out, especially if the pump is held horizontally.
 The 7095 comes with a 3/8” BSP gauge port fitted with a blanking plug and a 1/4" BSP
output port fitted with a capped Minimess 1620 test point.
 Use only bonded washers (Dowty) to seal adaptors.
 Use only with distilled water or mineral based hydraulic oil.
 Two bonded washers are fitted to seal the output port.
All Time Electronics' instruments are subject to continuous development and improvement and in
consequence may incorporate minor detail changes from the information contained herein.