TEKTON 4677 - 25 ft. x 3/8 in. Retractable Air Hose Reel - Manual (Page 5)

1. Use included mounting template to mark hole locations.
Use a level to position template. Tape securely in position
before marking. Remove template when finished.
3. Pre-install lower pair of hardware and tighten down
leaving just enough space to snugly fit base.
4. Hang hose reel by sliding slotted base onto
installed hardware. Carefully let go of hose reel,
making sure its weight is being supported. Hose
reel should support itself in this position long
enough to install remaining hardware.
5. Immediately install second set of hardware. Tighten all
hardware until snug. Do not overtighten.
CAUTION: CEILING MOUNTING REQUIRES TWO PEOPLE. DO
NOT ATTEMPT TO MOUNT HOSE REEL TO CEILING BY
YOURSELF. USING A LADDER CAN BE DANGEROUS AND IS
NOT RECOMMENDED.
1. Use included mounting template to mark hole locations. Tape securely in
position before marking. Remove template when finished.
2. Drill holes for bolts. Keep drill steady and in line with hole to prevent
wobbling and enlarging of hole.
3. Pre-install one pair of hardware and tighten leaving just enough space to
fit base.
4. Hang hose reel by sliding slotted base onto pre-installed hardware.
DO NOT LET GO OF HOSE REEL!
5. While continuing to support reel, install second pair of hardware. Tighten
all hardware until snug. Do not overtighten.
1. Use included mounting template to mark hole locations. Tape
securely in position before marking. Remove template when finished.
2. Drill holes for bolts. Keep drill steady and in line with hole to prevent
wobbling and enlarging of hole.
3. Set reel in position, aligning base with holes. Install all hardware,
tightening until snug. Do not overtighten.
CEILING
WALL
FLOOR
MOUNTING
TEMPLA
TE
2. Drill holes for bolts. Keep drill steady and in line with
hole to prevent wobbling and enlarging of hole.
WOOD - Lag bolt,
lock washer and
washer
4X 4X 4X
METAL - Bolt, two
washers, lock washer
and nut
MASONRY - Bolt, lock
washer, washer and
anchor
page 5
ATTENTION - Mounting bolts
can loosen with heavy use or over
time. Check condition of mounting
bolts every 6 months.