Ar ch ive d – Seametrics FT522 User Manual
Page 4
Repair
The only field-repairable component on the FT520 is the
fuse. If failure is due to a cause other than a blown fuse,
it is necessary to replace the entire board stack. Contact
your distributor for information.
Fuses. The power supply and the analog output circuit
have fuse protection. The two fuses are on the board.
Replace the blown power fuse with a 250 mA, 5x20 mm
glass fuse, available from SeaMetrics or from Radio
Shack (or other electronic supply store). The DC power
fuse is a 1 Amp, 5x20 mm glass fuse.
4 of 4
20419 80th Ave. So., Kent WA. 98032 USA
Phone: 253-872-0284 Fax: 253-872-0285
www.seametrics.com 1-800-975-8153
Caution: Always disconnect
power to the unit before open-
ing the terminal cover. Do not
reconnect power until all con-
nections have been made and
the terminal cover has been re-
placed.
5.50"
gasket
PANEL
CUTOUT
5.50"
6.03"
6.03"
1/4" holes (4 required)
Panel cut-out dimensions
!
AR
CH
IVE
D
- EX800-Series (12 pages)
- EX100-200-Series (16 pages)
- IP800-Series (12 pages)
- IP100-200-SERIES (12 pages)
- TX800-Series (12 pages)
- TX100-200-SERIES (12 pages)
- PE102 (4 pages)
- SEB (2 pages)
- SES (4 pages)
- S-Series (4 pages)
- MJ-Series (4 pages)
- MJN-Series (4 pages)
- WJ-Series (4 pages)
- WT-Series Turbine (4 pages)
- iMAG-Series (16 pages)
- WMX-Series (12 pages)
- WMX-Series (8 pages)
- WMP-Series (8 pages)
- AG2000-Series (4 pages)
- AO55 (4 pages)
- FT400-Series (12 pages)
- DL76 (4 pages)
- FT500-Series (8 pages)
- FlowInspector (16 pages)
- RSP5 (4 pages)
- PT35 (4 pages)
- PT34 (4 pages)
- PS40 (2 pages)
- PD10 (4 pages)
- PC-SERIES (4 pages)
- AD30 (2 pages)
- AG1000 (10 pages)
- AG2000 v.1 (4 pages)
- AG2000 v.2 (4 pages)
- AO45 (4 pages)
- DL75 v.1 (4 pages)
- DL75 v.2 (24 pages)
- EM 100-102 v.1 (4 pages)
- EM 100-102 v.2 (4 pages)
- EM 101 v.1 (6 pages)
- EM 101 v.2 (8 pages)
- EX100-200 Series v.1 (14 pages)
- EX100-200 Series v.2 (16 pages)
- EX80 Series v.1 (12 pages)
- EX80 Series v.2 (12 pages)