Satechi Cyclone Micro 2+ 1080p Portable Media (MKV, AVI, MOV) Player Adapter with SD/SDHC Memory, USB Slot and Remote Control - Manual (Page 34)

Cyclone Micro 2 Multimedia Player
Page 34.
Version 0.7
Please ensure that the device is also connected to your TV via the supplied
composite cable during the firmware update. When the screen goes blank,
select the composite connection as the active input on your TV.
The The The The player player player player no no no no longer longer longer longer responds: responds: responds: responds:
If the Cyclone Micro 2 no longer responds to the remote control, the batteries
may be dead. Please replace them with new ones.
Obstruction of the infrared’s field of vision may also cause unresponsiveness
in the player. Please remove all potential obstructions between the player
and remote control
Please clean the infrared receiver.
No No No No audio audio audio audio output: output: output: output:
Please check that the volume for your TV, home entertainment system and
Cyclone Micro 2 has not been set too low. Also check that the sound has not
been switch off via the mute button.
The audio digital output may also be incorrectly configured.
The The The The player player player player has has has has failed failed failed failed during during during during Firmware Firmware Firmware Firmware upgrade: upgrade: upgrade: upgrade:
To recover the Cyclone Micro 2 from a firmware upgrade failure, power off the
player and disconnect the power cable.
Insert a USB pen drive containing the firmware. Please note that only the
firmware update files should be on the pen drive.
Connect the power cable back into the Cyclone Micro 2 and switch it on. This
should cause the player to attempt to reinstall the software.