AEG LAVAMAT 14800 - Manual (Page 8)

Display
The display shows the following information:
• Duration of the selected programme (in minutes), calculated auto-
matically on the basis of the maximum recommended load for each type
of fabric.
• Selected drying time (max. 130 minutes for cotton, 100 minutes for
synthetics).
After the programme has started, the time remaining is updated every
minute.
• When the programme has finished, a steadily lit zero is displayed.
• Delayed start, (19 hours max.) programmed using the special button
. The countdown is updated every hour.
• Alarm code indicating a fault in the machine operation (see page 37).
Programme progress display
By selecting the wash programme, the pilot lights corre-
sponding to the various phases making up the pro-
gramme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme has
finished, the END
pilot light comes on.
When the programme has finished, if the OVERDOSAGE light comes
on, it indicates that too much detergent has been used or that the drain
filter is blocked.
15
The soak programme ends with a short spin in programmes for Cotton
and Synthetics, and with emptying of the water without spinning for
Delicates.
PREWASH
The machine performs a prewash cycle at 30°C max. The prewash cycle
ends with a short spin in programmes for Cotton and Synthetics, and
with emptying of the water without spinning for Delicates.
This option is not available with the wool programme and cannot be
used with SOAK
and STAINS .
For use when washing heavily soiled laundry.
Important: By depressing at the same time buttons
and the
machine will perform an extra rinse (see page 27)
SPIN SPEED
Press this button to reduce the maximum speed of the final speed
proposed by the machine for the selected programme or to select
option (RINSE
HOLD).
The maximum spin speed for cotton is 1400 rpm, for syn-
thetics and wool 900 rpm and for delicates 700 rpm.
RINSE HOLD
By selecting this option, the last rinse water is not emptied out, to
prevent the fabrics from creasing. When the programme has finished,
the pilot light
(END) on the programme progress display illuminates
to indicate that the water must be emptied out.
To empty out water:
• press the START/PAUSE button: after emptying, the machine performs
the spin cycle required for the type of wash selected;
• select the DRAIN programme “C” to empty out the water without
spinning.
Warning! The programme selector dial must be turned first to RESET O
and then to the DRAIN programme “C”.
If the water is not emptied out, the machine automatically empties
itself after 18 hours.
The RINSE HOLD option cannot be selected for the automatic WASHING
&
DRYING programme.
14
Description of the appliance Description of the appliance
MAIN WASH
EXTRA RINSE
RINSES
END
OVERDOSAGE
SPIN
DRYING
PREWASH
1400
1200
900
700
400