Hotpoint Ariston AVTF 109 - Manual (Page 19)

19
GB
Function Effect Comments Enabled with
programmes:
Super
Wash
Allows f or an
impeccable
wash, visibly
whit er than a
standard
Class A wash.
This funct ion is incompatible wit h the RAPID function.
1, 2, 3, 4,
5, 6, 7, 8
Easy i ron This opt ion
reduces t he
amount of
creasi ng on
fabrics, maki ng
them easier t o
iron.
When t his funct ion is set , programmes 6, 7, 8, 11 and
Delicate rinse will end wit h thelaundry left to soak
(Anti-crease) and the EASY IRON butt on flashes:
- t o conclu de the cycl e, press the START/RESET
bu tt on or the EASY I RON bu tton;
- t o run the draining cycle alone, set the knob to
t he rel at i ve symbol and press the START/RESET
bu tt on.
All
programmes
except for
1, 2, 9, 10
and
Draining.
Rapid Cuts t he
duration of t he
wash cycle by
30%.
This funct ion is incompatible wit h the SUPER WASH
function.
1, 2, 3, 4,
5, 6, 7, 8
Rinses
Personalisations
Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned on a
programme with a spin cycle, a fixed appears. Press button
and the maximum spin speed allowed for the programme set will be
displayed, and the the icon goes on. Press it again and the
values lower until they reach OFF, which indicates that the spin
cycle has been excluded (press it again to go back to the maximum
value); stop on the desired speed, after approximately 2 seconds
the setting is accepted: the symbol remains fixed.
The spin cycle setting is enabled with all the programmes except for
11 (curtains, silk) and the Draining cycle.
Setting the temperature
If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs
to be regulated, a fixed appears. Press button and the maximum temperature allowed for the programme
set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF,
which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value,
after approximately 2 seconds the setting is accepted: the symbol remains fixed.
The temperature adjustment is enabled with all wash programmes.
Setting the Delay Timer
Press the button and you will see the word OFF on the display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the
"desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set
programme appears on the display and the symbol remains on.
If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of
the cycle. In this phase, the "delay" can only be modified by decreasing it.
The Delay Timer regulation is enabled with all programmes.
Keyboard lock (See page 17)
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
If you set a function that is incompatible with another function you selected previously, only the last one selected
will be enabled.