AT&T DECT EL51109 - Manual (Page 5)

4
Telephone base installation
Install the telephone as shown below. The telephone base is ready for table
use.
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
, or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
2. The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
1. Plug one end of
the telephone
line cord into
the telephone
jack on the
bottom of the
telephone base.
2. Plug the small
end of the power
adapter into the
power jack on
the bottom of
the telephone
base.
If you have DSL high speed
Internet service, a DSL filter
(not included) is required.
5. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
4. Plug the large end
of an AC power
adapter into an AC
power outlet not
controlled by a wall
switch.
3. Route the power
adapter cord
through the slot.
Telephone line cord