AT&T E2901 - Manual (Page 13)

10
Getting started
Belt clip & optional headset
Install belt clip as shown below if desired.
Snap belt clip
into the notches
on both sides of
handset.
Plug 2.5 mm headset into
the jack on the side of hand-
set (beneath small rubber
cap).
To release belt clip
from handset, lift one
side of the belt clip
out of the notch.
For hands-free telephone conversations, use any industry standard 2.5 mm headset
(purchased separately). For best results, use an AT&T 2.5 mm headset. To
order an AT&T 2.5 mm headset, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
NOTE: If the sound quality of
the headset is not good, try
unplugging it, and firmly plug-
ging it in again.