GEAR4 AirZone Series 1 User Manual

Page 6

GEAR4 | AirZone Series 1 | User Manual

gear4.com/register
Please ensure that your iPod / iPhone / iPad
is using the latest software version. To update
the software, connect your iPod / iPhone / iPad
to iTunes. If there is a newer software version
available you will be prompted to upgrade.
Copyright © 2011 Disruptive Limited. All rights
reserved. Reproduction in part or in whole is
prohibited. GEAR4 and AirZone are trade marks
of Disruptive Limited. AirPlay, the AirPlay logo,
iPad, iPhone, iPod, iPod classic, iPod nano
and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
“Made for iPod”, “Made for iPhone” and “Made
for iPad” mean that an electronic accessory
has been designed to connect specifically
to iPod, iPhone or iPad respectively and has
been certified by the developer to meet Apple
performance standards.
Apple is not responsible for the operation of
this device or its compliance with safety and
regulatory standards.

WARNiNG

To reduce the risk of fire or electric shock, do
not expose this unit to rain or moisture.
The apparatus shall not be exposed to dripping
or splashing and that no objects filled with
liquids, such as vases, shall be placed on the
apparatus

Danger of explosion if battery is incorrectly

replaced. Replace only with the same or

equivalent type.

CAUTiON

Use of controls or adjustments of performance

or procedures other than those specified may

result in hazardous radiation exposure.
To avoid damage, never place the unit or its

batteries near radiators, in front of heating

vents, under direct sunlight or near water.
Batteries (battery pack or batteries installed)

shall not be exposed to excessive heat such as

sunshine, fire or the like.
Ensure batteries are inserted as indicated inside

the battery compartment.

UNPACkiNG AND iNSTAllATiON

Unpack your unit carefully. We recommend that

you save the packaging in case you ever need

to store your unit.

FOR yOUR SAFETy

‒ When disconnecting the power supply, pull

the plug first. Do not pull the cord by itself.

‒ Never handle the power plug with wet hands,

as this could cause fire or electric shock.

‒ Refer servicing to qualified personnel only.

‒ Do not open the housing.

‒ Do not twist or pinch the power supply cord.

If the plug or power supply cord needs to be

replaced, ensure that it complies with the
manufacturer’s recommendation.