DeFelsko PosiPen v.2.1 User Manual

Page 2

Operation:
Be sure the surface to be measured is clean and free from oil and grease. Hold the

PosiPen

at a right angle to the surface to be measured. Place the tip of the

PosiPen

on the coated surface and allow the magnet to contact.

Pull the

PosiPen

straight back from the object while keeping close watch on the

appropriate indicator. Note the reading when the magnet releases. Repeat if
necessary.

Indicators:
The

PosiPen

compensates for gravity when measuring in different positions. When

possible, hold the Gage horizontal, as for wall measurements.

1. Use the red/silver joining line when the Gage is horizontal (walls).
2. Use the green line when the Gage is pointing straight down (green=ground).
3. Use the blue line when the Gage is pointing straight up (blue=sky).

Calibration:
The

PosiPen

is shipped with a Certificate of Calibration. To verify gage accuracy, use

only traceable coated thickness standards.

Care:
Always return the

PosiPen

to its pouch. Extend the magnet to remove debris with a

cloth or dry paint brush.

Limited Warranty, Sole Remedy and Limited Liability
DeFelsko’s sole warranty, remedy, and liability are the express limited warranty,
remedy and limited liability that are set forth on its website:www.defelsko.com/terms

DeFelsko and PosiPen are trademarks of DeFelsko Corporation registered in the U.S.
and in other countries.

802 Proctor Ave.
Ogdensburg, New York 13669 USA
Ph: +1-315-393-4450 Fax: +1-315-393-8471
www.DeFelsko.com [email protected]