beautypg.com

Step 11, Step 12 – Catskill Craftsmen 51536 User Manual

Page 10

background image

STEP 11

A. Insert and tap caster sockets with

hammer until the teeth grab the wood.

DON’T POUND SOCKET FLAT OR

CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing

straight downward with heel or your hand,

or tap into place with a hammer. Don’t

be afraid to give them a good downward

whack on the solid metal part of the caster!
C. Locking wheels usually go on front.

ILLUSTRATION 11

STEP 12

A. Upright unit. Take bottom shelf (no edge

banding) and place it on the set of back

pins. Close doors and shelf will drop into

place.
B. Decide on position of middle

shelf, then tap two 1” pins into

each side panel, making sure the

pins on both sides are in the same

relative position. To remove a pin,

use pliers or claw hammer.
C. Place middle shelf, edge banding

out, on pins.
D. Insert drawer.
Note: If the top edge of the drawer

front hits the underside of the cart

top or the top edge of the top front

brace, loosen the machine screws in

the top front brace a little and adjust

brace down until drawer opens/closes

freely - check to make sure doors

open/close freely. Re-tighten all bolts!
E. Tap wooden disks into sides.

ILLUSTRATION 12

Edge

Banding