Catskill Craftsmen 51527 - Manual (Page 6)

STEP 4
A. Attach the drawer back to the drawer sides with four
1 1/4” #8 screws. Make sure parts are aligned as in
illustration 4A.
B. Insert drawer bottom into the slots in the drawer
sides, best side to inside of drawer. Slide down until
seated in the slot in the drawer back. See illustration
4B.
C. Screw the cam posts into the two outside holes on
the inside face of the drawer front until seated. Only
3/8” of the post goes into the wood, leaving the 4
larger guide rings/head exposed. See illustration 4C.
D. Insert the posts into holes in the drawer sides until
seated against the front ends of the drawer sides.
Insert cams so that the arrow on the outside face of
the cam points to the post. The slot in the cam fits
over the post. Turn with Phillips screwdriver until
seated. Don’t over-torque!! See Illustration 4D.
See our video online at www.catskillcraftsmen.com
E. Attach drawer handle with the two handle screws
(no illustration).
F. Attach drawer glides to drawer sides using
5/8” #5 screws. See illustration 4E.
ILLUSTRATION 4A
ILLUSTRATION 4B
ILLUSTRATION 4D
ILLUSTRATION 4F
ILLUSTRATION 4C
Below line in wood
Cam Posts (2)
4 used
in this step
1 1/4” Phillips Flat Head #8 Screw
2 used
in this step
7/8” Truss Head Machine Screw
2 used
in this step
Cam
4 used
in this step
5/8” Phillips Flat Head #5 Screw