Step 4 – Catskill Craftsmen 1526 User Manual

Page 6

STEP 4

A. Turn the side/back assembly ( from step 2 ) upside down ( invert ) on top of the inverted table top.

B. Drop two 1 1/4” # 8 screws into the holes in each of the table top sticks.

C. Using the (X) marks from step 3 as a guide, insert the tips of the screws into the pilot holes in the

unit top and finger tighten. When all 4 screws are properly aligned, tighten down.

D. Tap two 1” pins into each side panel. These pins will hold the bottom shelf. See illustration 4

1 1/4” Phillips Flat Head #8 Screw (12)

4 Used in this step

1” Long 3/16” DIA. Steel Pin (8)

ILLUSTRATION 4