Catskill Craftsmen 1527 - Manual (Page 11)

STEP 13
A. Insert and tap caster sockets with
hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT
OR CASTER SHAFT WILL
NOT ENTER.
B. Insert casters and seat by
pushing straight downward
with heel or your hand, or tap
into place with a hammer.
Don’t be afraid to give them
a good downward whack on
the solid metal part of the
caster!
C. Locking wheels usually go
on back, but can go diagonally
or on the front if cart is moved
a lot.
ILLUSTRATION 13
STEP 14
A. Upright Unit. Take bottom
shelf ( no edge banding )
and place it on the set of
back pins. Close doors
and shelf will drop into
place.
B. Decide on position
of middle shelf, then
tap two 1” pins into each
side panel, making sure the
pins on both sides are in the
same relative position. To
remove a pin, use pliers or
claw hammer.
C. Place middle shelf, edge
banding out, on pins.
D. Tap wooden disks
into sides.
ILLUSTRATION 14