Catskill Craftsmen 1576 - Manual (Page 4)

1 1/4” Phillips Flat Head #8 Screw
8 Used in this step
STEP A
1. Attach the Rack Top to the top ends of the Side Panels using 1 1/4” #8 wood screws. MAKE
SURE YOU HAVE THE RACK TOP! The only difference between the Rack Top and the Cabinet Top
is that the Cabinet Top has 4 small pilot holes on the bottom side plus the 4 throughholes; whereas,
the Rack Top only has the 4 through holes. NOTE: On the Rack Top the countersunk (reamed out)
through holes face up and the countersunk holes/pilot holes on the Cabinet Top face down.
The countersunk holes allow the screw heads to be flush with the wood surface when tightened down.
2. Turn this assembly upside down so that the Rack Top is on a smooth flat surface. Attach the
Cabinet Top with four 1 1/4” #8 wood screws. With the unit upside down at this point, the 4 pilot holes
should be up.
3. Leave this assembly UPSIDE DOWN and go to STEP 1. Looking ahead to STEPS 3 & 4,
the bottom of the Cabinet Top IS THE BOTTOM OF THE CART TOP ATTACHED TO THE RACK IN
STEP A4 ABOVE.
NOTE: The cart cabinet will be constructed
upside down using the bottom of the Cart
Top as the base.
ILLUSTRATION A
RACK TOP
CABINET TOP
PILOT HOLES HIDDEN
R1
R2
R2
T1