Catskill Craftsmen 1537 - Manual (Page 10)

STEP 10
Attach handle/towel bar to side panel with 1 1/4” #8 screws from inside side panel.
1 1/4” Phillips Flat Head #8 Screw (12)
2 Used in this step
STEP 11
A. Tap/insert ONE 1 1/2” pin
into each end of both doors.
DON”T OVERDRIVE PINS!
pins should stick up about 1/2”
when seated.
B. Attach the doorspace to the
left door with 5/8” #8 screws.
The spacer has a space at the
top to allow magnet clearance
and is almost flush with the
bottom of the door.
C. Attach the magnet plate
(may be stuck to magnet!)
with the small flat head screw
to the top of the right door.
D. Attach door handles with 1”
truss head machine screws.
1 1/2” Long 3/16” DIA. Steel Pin (4)
4 used in
this step
5/8” Phillips Flat Head #8 Screw (23)
3 used in this step
ILLUSTRATION 10
Magnet Plate (1)
1” Truss Head Machine Screw (6)
2 used
in this step
1/2” Phillips Flat Head #4 Screw (1)
2 used in this step
ILLUSTRATION 11
2 Used
in this step
3/16” Flat Washer (2)
NOTE: Put washers in between the screws and the Side Panel so the
screws don’t pull through the Side Panel.