American Weigh Scales TS-200 - Manual (Page 3)

I. OPERATION
Insert batteries and place the scale on a flat surface.
1. Press the [ON/TARE] key.
2. Wait until "0.0” is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [CAL/MODE] key, you can switch
between different weighing units.
II. TARE WEIGHING
The Tare function subtracts the weight of a container.
1. Turn on scale as described above.
2. Place the "tare item" (container) on the platform.
3. Press [ON/TARE] and wait until "0.0" is displayed.
4. Add the "net-weight-item" (weight of contents only).
III. CALIBRATION
Calibration is not required before first use. Only
calibrate if scale is not weighing properly.
1. Press [ON/TARE] to turn on the scale. Wait 30
seconds for the scale to warm up.
2. When the display shows "0.0" press and hold
[CAL/MODE] until the display flashes "AL"
3. Wait for about 5 seconds, the display will show "AL
0". Place a 100g calibration weight (not included) onto
the weighing tray.
4. Wait for about 5 seconds, if the display shows "AL
F", calibration is complete. It should return to normal
weighing mode.
5. If the scale shows "AL E" instead, an error has
occured. Repeat calibration.