Work Sharp WS2000 Tool Sharpener & Grinder User Guide - Manual (Page 7)

12 www.worksharptools.com www.worksharptools.com 1
STEP
Place tool in sharpening port under the
tool hold-down, on the right side of align-
ment fence.
STEP
Slide fence against left edge of tool in port
and hand tighten alignment fence knob.
STEP
Keeping the tool flat on the sharpening
port diamond surface; “plunge and pull”
the tool in and out of the sharpening port
to sharpen the bevel.
Only contact the wheel during “plunge” for
one-half to one second.
Repeat “plunge and pull” sharpening in
the sharpening port until a consistent
finish, or desired sharpness is achieved.
For best surface finish and sharpness, flip
wheel so fine abrasive is face down and
repeat step 5.
Edge-Vision TM
Underside Port—
For small carving tools,
screwdrivers, and general
grinding
☛ Tip
Use a permanent marker to color
the edge of your tool to be sharp-
ened.
Step 1
Mount the Edge-Vision TM slotted wheel
and turn unit around so you are facing the
underside port on backside of tool.
Step 2
Slowly bring tool into the Edge-Vision TM
underside port under the wheel.
Pull
Step
Look down through the spinning Edge-
Vision
TM wheel to see the cutting edge.
Sharpen the tool to your desired shape and
sharpness.
☛ Tip
Use a shop light to shine through
the top of the Edge-Vision™ wheel
to improve your view of the tool
being sharpened.
Topside Freehand
Sharpening
(top tool rest
use optional)—For putty knives,
scrapers, axes, hatchets and
other flat-blade tools
Step 1
Mount the Edge-Vision™ wheel onto the
unit.
Step 2
Lay blade face onto the right side of grind-
ing wheel.
Step
Pull blade towards you keeping blade face
flat on the grinding surface.
Plunge
Step
Raise tool or handle to create or re-sharp-
en a beveled edge if desired.
Step
Repeat this step on the other side of the
blade tool being sharpened. Continue until
desired finish or sharpness is achieved.
General Purpose
Grinding
Larger work pieces are best ground using
the top side of the Edge-Vision
TM wheel.
You can use either slotted or solid abrasive
media for these tasks. Smaller work pieces
are best ground using the Edge-Vision
TM
wheel with slotted abrasives and the
Underside Port. This enables you to take
advantage of the Edge-Vision’s unique
ability to let you see through the wheel
and actually see the material surface as
you grind it.
Pull slowly
towards you
Rotation
Edge-Vision TM Port
Use side-to-side motion