WEN 2305 Rotary tool kit manual rev.2013 User Manual
Page 12
12
The cable will become loose from the jacket and will uncontrollably whip or lash around.
1. Turn the tool off.
2. Remove the housing cap from the tool.
3. Press the Spindle Lock Button, unscrew the collet nut.
4. Pass the end of the Flexible Shaft Core through the Collet Nut, and into the Collet. Note:
it may be necessary to pull out a few inches of the core from the shaft housing. Depress
the Spindle Lock, and hold it down while tightening the Collet Nut with the Wrench.
5. Attach by screwing the collar of the flex-shaft to the rotary tool.
Installing a bit in the flexible shaft
1. Use the Round “L” Tool to prevent the Flexible
Shaft Core from turning by inserting it into the hole
in the side of the Flexible Shaft Handle.
2. Once “L” Tool is in place, remove the Collet locking
nut by turning it counterclockwise with the Wrench.
3. Place the bit into the appropriate sized collet.
4. Place the collet into the end of the Flexible Shaft
Handle.
5. Place the Collet Locking Nut over the bit, and
tighten it by turning clockwise.
6. Tighten in place using the Wrench and the Round “L”
Tool.
Flex Shaft
Collar
Flexible Shaft Core
Collet Nut
Spindle Lock Button