WEN 4016 16 Electric Chainsaw - Manual (Page 10)

10
CUttInG InStrUCtIonS
WarnInG - always follow safety procedures. Use the chain-
saw only for cutting wood and not other types of materials.
Do not use the chainsaw as a lever for lifting, moving or
splitting objects. never cut in high wind, bad weather, poor visibil-
ity conditions, or in extreme temperatures. always check for dead
branches which may fall during cutting operations.
In all circumstances, the operation of a chainsaw is a one man job. Keep all
other people away from the cutting area. It is difficult enough to take care of
your own safety without assuming responsibility for the safety of others.
- Before felling a tree, study the surrounding area to determine where you
want the tree to fall. Select a retreat path. The path should be at a 45 degree
angle from the tree fall line. (Fig.14)
- Clear the work area before beginning the cutting process. Remove the
undergrowth from the base of the tree and check the area for obstacles so a
clear retreat path exists.
- Start by cutting off any branches up to shoulder height. Do not cut above
shoulder height and always use two hands in gripping the saw.
Never use the saw one-handed.
- Begin the cut on the side to which the tree is to fall. Cut a notch about 1/3rd
of the way into the tree. The position of the notch is important since the tree
will try to “fall” into the notch. (Fig.15)
- The felling cut is made on the opposite side of the notch at about 2” above
the center of the notch. Do not cut through to the notch with the felling cut.
The wood between the notch cut and the felling cut will act as a hinge when
the tree falls, guiding it in the desired falling direction. (Fig.15)
- When the tree starts to fall, turn off ignition switch, place the chainsaw on the
ground and retreat to a safe position at least 10’ from the trunk.
- To fell bigger trees with diameters exceeding twice the bar length requires
specialized skills and should not be attempted without proper training.
Before use: Check that the chain brake works properly and is not damaged. Visually inspect
the entire saw to ensure all components are free from damage and work properly. Check the
chain tension and adjust if necessary.
14
15