Applica LitterMaid LME9000MB User Manual
Page 5

Assembly
1. Slide receptacle supports (marked L (left) and R (right)) into
grooves on the bottom tray until they lock into place
(A).
2. Place both left and right flaps flat on top of the waste
receptacle compartment panel.
3. Push the flaps in and up until they click into place
(B).
4. Lift the flaps until they lock into place
(C).
5. Snap each pivot of the waste receptacle compartment cover,
one at a time, into notches in the receptacle supports
(D).
6. Open waste receptacle compartment cover.
Important: Waste receptacle compartment cover must be
opened to remove and install top housing.
7. Lift top housing. Angle into position bracket end of top
housing under tray ledge.
Important: 5 black tabs of the tray
should be on top of the grey bar in front of the top housing
(E). Bring the other end of top housing down so that it
snaps into place. Check to be sure top housing is positioned
securely on the tray. If positioned correctly, you will not be
able to read writing on silver tray ledge.
8.
Insert waste receptacles.
• Open waste receptacle compartment cover.
• Insert a disposable waste receptacle into the waste
receptacle compartment.
• Insert the edge of the waste receptacle in an inclined
position and place it between the edge of the tray and the
bar of the top housing
(F).
• Press the waste receptacle down into position
(G).
• There should be no gap between the unit and the waste
receptacle.
8
7
• Attach the waste receptacle lid by inserting the push tabs
into the round holes. To secure, press on positions indicated
(H).
Make sure lid edges are under the cover tabs
(J).
9.
Install carbon filter.
• Peel off the paper strip on the carbon filter to expose the
adhesive.
• Place filter adhesive-side down in the diamond-shaped insert
in the center of the waste receptacle lid
(K). Close the waste
receptacle compartment cover.
10. Fill the LitterMaid® litter box with litter to just below the
Full Line marked inside of litter tray
Important: Use only hard clumping litter. Do not use non-clumping litter, crystal
or pearl-like litters.
Recommended Hard Clumping Liters
• LitterMaid™ Hard Clumping Cat Litter
• World's Best Cat Litter™
• ARM & HAMMER® Super Scoop® The Baking Soda Clumping Litter
• Fresh Step® Scoopable Premium Cat Litter
• EVER CLEAN® Premium Clumping Litter
Do not overfill the unit or it will not operate properly.
• Use the Fill Line on the LitterMaid® triple-action tool
to check that the litter is at the correct level in the center
of the unit
(L).
The LitterMaid® Triple-Action Tool
This handy 3-way tool helps you:
• Measure the level of litter
(M).
C
E
J
K
L
M
B
A
D
F
G
H