WEN 946 7 Inch Variable Speed Polisher / Sander - Manual (Page 7)

7
WARNING - when servicing use only identical WEN ® replacement parts. use
of any other part may create a hazard or cause product damage.
WARNING - dO NOt OPERatE tHIS tOOl WHIlE uNdER tHE
INfluENCE Of dRuGS, alCOHOl OR aNY mEdICatION tHat maY
ImPaIR YOuR JudGmENt OR CONtROl!
• Never use in an explosive atmosphere. Normal sparking of the motor could ignite fumes.
• use only outdoor extension cords with approved ground connection that are intended for use
outdoors and so marked.
• avoid awkward operations and hand positions where a sudden slip could cause your hand to
move into the blade. alWaYS make sure you have good balance.
• allow the motor to come up to full speed before starting a cut to avoid binding or stalling
• do not use tool if switch does not turn it on and off. Have defective switches replaced by an
authorized service center.
• Replacement parts. all repairs, whether electrical or mechanical, should be made by a qualified
service technician at an authorized service center.
• Keep hands away from cutting area. do not hand hold pieces so small that your fingers go under
the blade guard. do not reach underneath work or in blade cutting path with your hands and
fingers for any reason.
• before making a cut, be sure all adjustments are secure.
• always support large work pieces while cutting to minimize risk of blade pinching and kickback.
tool may slip, walk or slide while cutting large or heavy boards.
• do not remove jammed cutoff pieces until blade has stopped.
• Never start the tool when the blade is in contact with the work piece.
• Never touch blade or other moving parts during use.
• before changing the setup, removing covers, guards or blades, unplug the tool and remove the
switch key.
• always turn off tool before disconnecting it to avoid accidental starting when reconnecting to a
power source.