Vitrex GO200VT - Manual (Page 2)

dangerous and must be repaired.
c. Disconnect the plug from the power source and/or battery pack from the power tool before making any adjustments, changing
accessories, or storing the power tool. Such preventative safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to
operate the tool.
Power tools are dangerous in the hands of untrained users.
e. Maintaining power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
f. Tools with sharp points are more likely to injure. Always remove the tip when done working with the power tool. Never store a power
tool with a tip still inserted in the tool.
g. Use the power tool, accessories, etc. in accordance with these instructions, taking into account the working conditions and the work to
be performed. Use of the power tool for operations different from those intended could result in a dangerous situation.
5) Service:
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of
the power tool is maintained.
Product description:
Vitrex Grout Out - Electric Grout Remover has been designed to power through old and discoloured grout with the pointed and chisel tips
provided. The easiest way to refresh any tiled area.
Specifications:
Power: 0.20A (13W)
Power supply: 120V~60Hz (230V~ 50 Hz)
Max. Stroke: 7100 min
-1
(6000 min
-1
)
Diameter of bit: Ø3.2mm
Installing the tips:
WARNING: The mains plug must be disconnected before making any adjustments.
1. Insert the hexagonal key provided into the screw head at output shaft.
2. Choose the suitable tip for your job. The pointed tip can be used on all cement based grout joints sanded or non-sanded, when the
grout width is 3mm (1/8") or less. The chisel tip is best used for varying widths of grout, for example shower, bath & sink areas, floor
tiles, wall tiles, fireplace tiles, etc.
3. Turn the hexagonal key anti-clockwise and place the tip into the tool.
4. Ensure the tip is fully inserted into the tool.
5. Turn the hexagonal key clockwise to tighten the tip. Once tightened, gently pull on the tip to check it is securely fastened in place.
NOTE: Do not over tighten as you might damage the hexagonal key and/or screw head.
Use:
NOTE: Always wear safely glasses, dust mask, and hearing protection when using Grout Out - Electric Grout Remover. Grout Out is only
suitable for interior re-grouting jobs.
1. Make sure that the tip is securely fastened.
2. Connect to power source.
3. Hold the Electric Grout Remover at a 45 degree angle.
4. Switch to “1” to turn the tool on.
5. Initially, the tool should be run at low speed applying minimal pressure to remove grout. Increase speed and pressure as required for
optimal performance. Applying too much pressure will cause the tool to stop vibrating.
6. Switch to “0” to turn the tool off.
NOTE: Please ensure appropriate tip is used for the grout joint to be worked on. Check the width of the tip against the grout line to ensure
that the tip does not touch the tile, as the supplier will not accept liability for any possible tile damage.