Vitrex WSPP600IND - Manual (Page 3)

Power Pro 600 Tile Cutter
04 05
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
Replacing the Cutting Disc (FIG. E)
Only use sharp and undamaged cutting
discs. Cracked or bent cutting discs must be
replaced immediately.
• Unscrew the housing (12).
• Use spanners to remove the screw (13).
• Remove the outer flange (14), the old
cutting disc (15)with the plastic protective
cover(16) and the inner flange (17).
• Clean the flanges.
• Place the inner flange, the new cutting
disc and the outer flange. When fitting the
cutting disc, make sure that the direction
of rotation corresponds to the arrow on
the housing.
• Fit the screw and use spanners to securely
tighten it.
• Fit the housing using the screws. Before
replacing the cutting disc always
unplug the tool. Make sure that the spindle
diameter and the bore match. Do not use
an adapter to mount a cutting disc with a
larger bore.
Cutting Tile (FIG.F)
When cutting tile,the tile will proceed as the
arrow by the push of hand.One side of the
tile is against the ruler(8).
Switching On and Off
• To switch the machine on, set the on/off
switch (6) to ‘I’.
• To switch the machine off, set the on/off
switch (6) to ‘0’.
Fitting the Pump
• Lower the pump (5) carefully in the water.
• The mains cable and hose should not be
pulled tight and the pump should not be
pulled out of the water.
Never let the pump run dry. Always make
sure that the suction opening is fully
immersed.
Cleaning and Maintenance
The machine does not require any special
maintenance.
• Regularly check the machine for possible
damage.
• Store the machine in a dry place, out of
reach of children.
Instructions for Use
• Before switching the machine on, make
sure that the water pump is immersed.
• Switch on the machine before the cutting
disc touches the workpiece.
• Place the workpiece against ruler.
• Push the tile with hands to guide the work
piece through the cutting disc.
• Do not exert pressure on the cutting disc.
Allow the machine enough time to cut the
workpiece.
• Regularly check if the cutting disc is
sufficiently cooled.
• Make sure that the pump is well below the
water. Add some cooling water if
necessary.
Machine Specification & Electrical Requirements
Mains voltage V 230V-110V
Mains frequency Hz 50
Power input W 600
No load speed min-1 2980
Disc diameter mm 200
Wheel bore mm 22.2
Max. cutting depth mm 30
Mitre angle ° 0-45
Bevel ° 0-45
Table dimensions mm 500 x 600
600 Weight kg 29kg
*Note: If the sound intensity level exceeds 85 db (A) ear protection should be worn by the operator
FIG.A
FIG.B