Vitrex MIX850 - Manual (Page 4)

06 07
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
850W Power Mixer
Specifications MIX850IND MIX850
Power Supply 110V 50Hz 230V 50Hz
Motor 850W 850W
RPM (no load) 0–550 rpm 0–550 rpm
Number of Gears 1 1
Mixing Paddle Diameter 120mm 120mm
Thread For Fixing M14 M14
Q.E.P. Co UK Ltd is committed to a continuing program of
product improvement. Consequently, please be advised
that specifications, performance, appearance, and
dimensions of QEP/Vitrex products are subject to change
without notice. For more up-to-date information about our
range of products, please contact our Customer Service
Office on +44 (0)1253 789180 or your local distributor.
Consumer Advice
• Do not dispose of electrical products
with your normal householdwaste.
• Always use recycling facilities
whenever possible.
• Additional recycling information can
be found through your local Authority
or Retailer.
• For further information or advice, please
call the Vitrex Technical Helpline on
+44 (0) 1253789180.
This Power Mixer has been manufactured to a high quality standard. It is guaranteed against faulty materials and
workmanship for 12months from the date of purchase. Any claim must be accompanied by a valid till receipt as proof of purchase.
A faulty machine will either be repaired or replaced free of charge. If a direct replacement is not available, an alternative to the
same or greater value/specification will be offered.
This guarantee does not cover machine defects caused by or resulting from:
a) Misuse, abuse or neglect, b) Trade, Professional or hire use, c) Repairs attempted by anyone other than our authorised repair
agent, d) Ingress of foreign objects, substances or accident
In the unlikely event of a fault occurring, contact should be made through the Vitrex Technical Helpline +44 (0) 1253 789180
The above guarantee is only valid within the UK and does not affect your statutory rights.
The guarantor is Q.E.P. Co. UK Ltd., Everest Road, Lytham St. Annes, Lancashire, FY8 3AZ (Registered No. 04988177 England).
CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
Always store your power tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer,
their service agent or similarly qualified person in order to avoid hazard.
If a fault cannot be rectified, return the mixer to authoris ed dealer for
repair.
Cleaning
• Keep the safety devices, ventilation slots and motor housing as free of
dirt and dust as possible. Clean the unit by rubbing it with a clean cloth or
blow it clean using low-pressure air compressor.
• We recommend that you always clean the unit immediately after using it.
• Clean the unit regularly by rubbing it with a damp cloth and a little soap
shaft. Do not use cleaners or solvents; these will attach the plastic parts in
the unit. You must also ensure that water cannot get into the inside of the
unit.
Carbon brushes
• If excessive sparking occurs you must have the carbon brushes checked
by a qualified electrician
•
Attention!
Only a qualified electrician is allows to change the brushes
Maintenance
• There are no parts fitted inside the unit that require maintenance.
For your own safety, never remove parts or accessories of the electric tool
during operation. In case of fault or damage have the electric tool repaired
only by a specialist workshop or by the manufacturer.