Vitrex 103402NDE - Manual (Page 5)

04
Machine Specification & Electrical Requirements
Power Supply 230v 50Hz
Motor Hi-Torque Geared Motor
RPM (No load) 4600 rpm
Maximum Depth of Cut (with new blade) 25mm
Maximum Depth of Cut at 45° (with new blade) 17mm
Mitre Cutting Angle 22.5/45 degrees
Cutting Angles 0-45 degrees
Note: If the sound intensity level exceeds 85 db (A) ear protection should be worn by the operator
• Ensure that the mains voltage
corresponds to the instruction plate
– a single phase socket with two
contacts and an earth is obligatory.
• Use of an approved RCD circuit breaker
between the machine and the electrical
power point is highly recommended.
• To reduce the risk of unintentional
starting, make sure that the switch
is in the OFF position before plugging in.
• Repair or replace damaged or worn
cable immediately after first
disconnecting from
mains supply.
• Electrical faults must only
be carried out by a
qualified electrician.
The contents of the box should include
the following (See pic below):
• Compact Tile Cutter
• Blade Assembly Set comprising of
110mm Diamond Blade, blade carrier,
blade washer, blade securing nut,
splashboard and splashboard
securing screw
• Blade guard set comprising of bolt,
wing nut, washer, guard support and
blade guard
• Rip Guide and securing nuts
• Variable Angle Mitre Guide
• Clip On Extension Table
• Owner’s Safety & Operating Manual
IMPORTANT
Your new Vitrex Torque-Master Power Compact Tile
Cutter contains a unique Hi-Torque geared motor,
which when in use produces a distinctive loud sound.
This is a characteristic of the High Performance motor
and is important in producing the torque for optimum
cutting performance.
For best results allow the blade to do the work, rather
than forcing the tile through the machine. Should the
blade stop, simply ease the tile away and then
continue cutting using slightly less pressure.
Tel: +44 (0) 1253 789180
COMPAC
T TileCu
tter
Owner’s
Safetya
nd Opera
ting Man
ual
10 3402
NDE