Vitrex 800100 - Manual

Laminate Cutter
800100
• Always wear safety glasses when operating this tool
• Keep cutting blade in the fully closed position when not in use
• Keep fingers and hands away from blade cutting area
• Periodically check that all hardware remains tight
1. Place cutter on the floor making sure it is on a level surface.
2. Mark the work piece to be cut and insert it against the backstop.
The “V”-Support should be used to support the laminate while
cutting. The cutting line is the edge of the blade, on either side.
3. Always cut laminate with the finished side up. Place the
grooved or indented side of the laminate against the backstop.
(The “tongue” side should be closest to the blade.)
4. Begin the cut by holding the laminate firmly with one hand and
cutting into the laminate with the blade approximately 1/2”.
You now have started your cut. Proceed using both hands with
a smooth powerful downward motion to complete your cut.
5. Remember the cut side will always be placed along the
wall to be covered up by skirting board or finish molding.
• Keep cutter clean and store in a dry place when not in use
• Periodically check all assembly to ensure that hardware remains tight
SAFETY WARNINGS FOR 800100 LAMINATE CUTTER
WARNING!
OPERATING INSTRUCTIONS
MAINTENANCE
Made in China
Vitrex Ltd., England www.vitrex.co.uk
Technical Helpline 01253 789180
Q.E.P Co. UK Ltd. is committed to a continuing program of product improvement. Consequently,
please be advised that specifications, performance, appearance and dimensions of QEP/Vitrex
products are subject to change without notice. For more up-to-date information about our range of
products please contact our Customer Service Office on +44(0)1253 789180 or your local distributor.
WARNING Read and understand all instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
OWNER’S MANUAL