Video Mount Products GU-3 - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-
ed that the installation of the mount be done by a professional.
Step 2
Attach the welded bracket to the top plate using the lock
washer and hex nut .
Step 3
Mark the wall or desired mounting surface in preparation of instal-
lation of top plate . Pre-drill if necessary and mount top plate
to desired surface. Warning: Please verify that your mounting
surface will support the combined weight of your mount, mount-
ing hardware, and antenna mast. Also verify that the mounting
surface is safe to drill through. If in doubt, please contact a profes-
sional installer.
Step 4
Place the antenna mast into the cup on the welded bracket .
Place the bracket on the opposite side of the antenna mast
and use the carriage screw and hex nuts to clamp the
bracket and welded bracket together to clamp the an-
tenna mast in place.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the welded
bracket to the top plate
Step 3: Attaching the top
plate to the mounting surface
WARNING: The installer must verify the installation meets all ap-
plicable codes and survival requirements. Video Mount Prod-
ucts will not be held liable for the improper use or installation of
its products.
Enjoy Your Mount!
3
3
2
4
2
7
1
5
2
1
1
6
Step 4: Clamping the antenna
mast in place