Enjoy your mount – Video Mount Products PDS-LCM2B User Manual
Page 4

Step 5
Attach the mounting adaptor PDS-LCM2B to the pipe couple
PDS-LCB using the metal washers PDS-LCB, PVC washers
PDS-LCB and nylon nut PDS-LCB. After tightening down
the nylon nut completely insert the cotter pin PDS-LCB though
the hole in the bottom of the screw of the pipe couple.
Step 6
Slide either extension brackets A or B or PDS-LCB / or
PDS-LCM2B onto the mounting plate PDS-LCB / PDS-
LCM2B and match up the slots on the extension brackets to the
holes on the back of your TV. Determine the correct screw size
and if you need to use washers, lock washers, or spacers. Note:
Spacers are used for TVs with recessed hole patterns. Secure the
TV to the extension brackets or PDS-LCB / or PDS-
LCM2B using the appropriate hardware through PDS-LC/
through PDS-LCM2B. Secure extension brackets with
5/16” screw PDS-LCB / PDS-LCM2B and washer PDS-
LCB / PDS-LCM2B.
Step 7
Lift the mounting bracket PDS-LCM2B / PDS-LC onto the
adjusting bracket PDS-LCM2B / PDS-LCB. WARNING: This
step requires at least two people to prevent possible injury. Secure
the plates together using the M5 security screw PDS-LCM2B /
PDS-LCB and washer PDS-LCM2B / PDS-LCB.
Please verify that all nuts and screws are securely tightened.
Step 5 : Attaching the mounting
adaptor to the pipe couple
27
28
WARNING: The installer of these products must verify that the
mount surface, ceiling or wall, will safely support the combined
weight of all attached equipment and hardware. Video Mount
Products will not be held liable for the improper use or installation
of its products.
Enjoy Your Mount!
1
13
4
Step 6A: Attaching the mounting rails
to the flat panel
(holes are not recessed)
Step 6B: Attaching the mounting rails
to the flat panel (holes are recessed)
Step 7: Attaching the mounting
brackets to the adjusting brackets
4
6
44
7
45
18
42
3
17
28
4
18
42
27
41
6
20
5
19
17
3
11
25
2
16
29
43