Filling & operation – Vapamore MR-75 Amico User Manual

Page 5

FILLING & OPERATION

Fig.1

GO TO VAPAMORE.COM TO SEE THE MR-75 AMICO INSTRUCTIONAL VIDEO

GENERAL FUNCTION: The MR-75 Amico steamer uses a heated boiler tank filled with water

to create steam. When first plugged in you will see the red power light showing that the

unit is powered on and heating. Once at full temperature the light will turn green showing

the steamer is ready for use. This light will change back and forth from red to green during

use as the heater cycles on and off. The steamer can be used anytime after the initial

heating and when the light is cycling between colors. The steam pressure will fluctuate

as the steamer is being used and the boiler cycles on and off during use.

Using additives of any kind will void the warranty.

Only fill with distilled water. Using “hard” mineral heavy water will clog

internal components and can cause failure to internal parts and void the warranty.

Fig.2

300ml / .32qt

Push down

and turn.

Plug in the steamer to a grounded 110 outlet. The steamer

is ready for use. (Initial start up from cold machine is aprox.

4 min) *The status light will cycle red to green during use

as the boiler maintains the temperature. Fig. 3

Vapamore

Fig.3

Red light when

plugged in.

Green light when

ready for use.

NOTE:

If steamer is hot, allow

Unscrew the tank cap by pressing the cap down and

simultaneously turning counter clockwise. Fig. 1

Use the supplied measuring cup filled with distilled water

to the 200ml MAX line. Fig. 2

Replace the water tank cap by pressing down on the cap

and simultaneously turning it clockwise. Make sure the

cap is fully tight to prevent any steam from leaking out.

and once cooled down tighten cap further.

Always make sure the steamer is not plugged in and

is cool before filling with water.

steamer to cool down completely before removing water

tank cap.