USGlobalsat BT-368i User Manual - Manual (Page 8)

BT-386i
Page 8 of 15
Version 1.1
4. Getting Start
Step 1: Charging the Battery
First it’s important to fully charge your BT-386 using the included charger cable, which can be connected to
either the included 12VDC car charger or a computers USB port. You will know that the charging process has
been completed when the orange “charge” LED is off.
Step 2: Turning On the Power
Press and hold the power button for one second to turn on your BT-368i.
Step 3: Getting a GPS Fix Signal
Place your BT-368i in a place where it can have a clear view to the sky and monitor the green GPS LED until it
begins to flash indicating is has fixed to satellite positions. This may take up to 3-minutes for the first time
your BT-386i is used. Thereafter a shorter fix time should be experienced.